Water filter indicator won't reset or keeps flashingUpdated 3 hours ago
If a filter replacement indicator on your Sans Water Purifier keeps flashing after you’ve changed a filter, work through these steps.
1. Check the filter is locked in
Remove the tap water tank and check the filter you replaced. For the Pre + Carbon and RO filters, push the filter in, then push the tab down until it clicks into place. For the VOC Carbon filter, make sure it’s twisted clockwise until it locks and pushed fully back in.
2. Reset the indicator
- Press and hold the reset button to enter reset mode.
- Tap to select the filter type you replaced.
- Press and hold to confirm. Keep holding until the filter indicator stops flashing.
The light goes off a few seconds after the reset. If you replaced more than one filter, repeat the reset for each one.
3. Watch the troubleshooting video
Our troubleshooting video shows the reset and what to do if a filter feels stuck.
Still flashing? Contact us at [email protected] or via live chat. A short video of the control panel helps us sort it out quickly.